Introduction - Argox AS-9500 User Manual

Introduction

Installation
RS-232
1) Disconnect power to the terminal/computer.
2) Connect the external power supply (DC adapter) to the serial
interface cable of the scanner.
3) Plug the serial connector into the serial port on the back
of your computer/terminal. Tighten the two screws to secure
the connector to the port.
4) Plug the power pack into power source.
5) Once the scanner has been fully connected, turn the
terminal / computer power back on.
USB (HID)
1) Connect the USB cable between scanner and PC.
2) Windows will automatically detect the USB device.
USB (Virtual-COM)
1) Install driver, USB Virtual COM Driver, from CD-ROM,
The driver will use the next available COM port
number
2) Connect the USB cable between scanner and PC.
3) Windows will automatically detect the USB device.
Note: If any of the above operation is incorrect, turn off the
power immediately and check any improper
connections. Go through all above steps again
.
8