Connecting Cables To Terminals - Kenwood KRC-578R Instruction Manual

Connecting Cables to Terminals

Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
(KRC-678R/
678RV only)
A–7 Red
A–8 Black
Speaker
Connector
Purple
B–1
Purple/Black
B–2
Gray
B–3
Gray/Black
B–4
White
B–5
B–6 White/Black
B–7 Green
B–8 Green/Black
Antenna Cord (ISO)
FM/AM antenna
input
Rear right
output (Red)
Functions
Battery
Power Control
Dimmer
Battery cable (Yellow)
Ignition (ACC)
Ignition cable (Red)
Earth (Ground)
Connection
+
Rear Right ( )
–
Rear Right ( )
A–4 Pin (Yellow)
+
Front Right ( )
–
Connector A
Front Right ( )
+
Front Left ( )
–
Front Left ( ) Connector B
+
Rear Left ( )
–
Rear Left ( )
Rear left
output (White) Front left
output (White)
Fuse (10A)
Front right
Wiring harness
output (Red)
(Accessory1)
TEL mute cable (Brown)
If no connections are
made, do not let the cable
come out from the tab.
Power control/ Motor
antenna control cable
(Blue/White)
A–7 Pin (Red)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
— 34 —
KENWOOD disc changer / DAB control input /
Display Data Output Jack
Outputs data representing the unit's current
state, causing it to appear in the external
display.
To connect to this jack, a converting adapter
(optional) is necessary.
NOTE
To connect the Disc changer or DAB unit,
consult each manual.
Connect to the terminal that is
grounded when either the
TEL MUTE
telephone rings or during
conversation.
NOTE
To connect the KENWOOD
navigation system, consult
your navigation manual.
Connect either to the power
control terminal when using
P.CONT
the optional power amplifier,
ANT.CONT
or to the antenna control
terminal in the vehicle.