Connecting Wires To Terminals - Kenwood KDC-W534U Instruction Manual

Connecting Wires to Terminals (KDC-W6534U)
USB connector
To External Display/ Steering remote
Rear left output (White)/Sub
Woofer left output (White)
Rear right output (Red)/Sub
Woofer right output (Red)
Fuse (10A)
Wiring harness
(Accessory1)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
To USB device
Front left output (White)/
Front right output (Red)
To Kenwood disc changer/ External optional accessory
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page
A-–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
• Do not remove the cap when you do not use the USB
cable. The connector will cause the unit to malfunction if
it gets in touch with any metallic part of the vehicle.
AUX right input (Red)
AUX left input (White)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
FM/AM antenna
input
To connect these leads, refer to
the relevant instruction manuals.
Connect to the terminal that
is grounded when either the
MUTE
telephone rings or during
conversation.
To connect the Kenwood
navigation system, consult
your navigation manual.
Connect either to the power
control terminal when using the
optional power amplifier, or to
P.CONT
the antenna control terminal in
ANT.CONT
the vehicle.
Antenna Cord (ISO)
37
|
English