Set Brew Volumes - Bunn single sh dbc Operating Manual

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
BREW OZ (SETTING OR ADJUSTING BREW VOL-
UMES)
This function allows adjustment of the brew vol-
umes for each batch. The indicator signifies volume in
ounces per batch.
Procedure for modifying recipes - brew ounces:
Range: 10.0 oz to 400 oz for all three batch sizes
1. Press and hold the ® pad until the display reads
SET NEW RECIPES. Release the ® pad. Press the
® until the display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO NAME, along with MODIFY, SHOW and
NEXT.
3. Press and release NEXT to advance to the desired
coffee name to be modified.
4. Press and release MODIFY. The display should
read BREW OZ and a batch light will be blinking.
Press and release the batch size to be modified.
5. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed over the grounds for that
particular batch size.
6. When finished, press another batch size and re-
peat step #5 for that size for each batch size to be
modified. Continue setting all batch sizes.
7. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
8. If the three batch sizes are not correct, press and
release NO to return to the BREW OUNCES setup
screen and repeat steps 5, 6 and 7.
9. If the three batch sizes are correct, press YES. This
will advance to the % BYPASS function. Another
alternative is to press the
BREW OZ setup and return to the MAIN SCREEN.
P2443
Page 18
pad to exit the
34025 100501