Table of Contents
Advertisement
SAFETY
INFORMATION
Continued
12. Do not use heater if any part has been
exposed to or under water. Immediately
call a qualified service technician to in-
spect the room heater and to replace any
part of the control system and any gas
control which has been under water.
13. Do not operate heater if any log is bro-
ken. Do not operate heater if a log is
chipped (dime-sized or larger).
14. Turn heater off and let cool before ser-
vicing, installing, or repairing. Make sure
the selector switch is in the OFF posi-
tion. Only a qualified service person
should install, service, or repair heater.
15. Make sure the selector switch is in the
OFF position when you are away from
your home for long periods of time.
16. This heater must not be connected to
any external electrical source.
17. Operating heater above elevation of
4,500 feet may cause pilot outage.
18. Provide adequate clearances around air
openings.
PRODUCT
IDENTIFICATION
®
Flame-Max
Vintage Logs
Optional
Remote
Control
Piezo
Ignitor
Optional
Selector
Switch
Figure 1 - Product Identification
105189
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
National Fire Protection Association, Inc.
Note: Where listed vented decorative logs
are required, thermostat operation is not
permitted.
UNPACKING
CAUTION: Do not remove the
data plates from the grate assem-
bly. The data plates contain impor-
tant product information.
1. Remove logs and heater base assem-
bly from carton. Note: Do not pick up
heater base assembly by the burner.
This could damage heater. Always
handle base assembly by grate.
2. Remove all protective packaging ap-
plied to logs and heater for shipment.
3. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
Flame
Adjustment
Knob
Control Knob
OWNER'S MANUAL
1430 Broadway
New York, NY 10018
Batterymarch Park
Quincy, MA 02269
One Piece
Log Set
Base Assembly
3
PRODUCT
FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANSI Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free
heaters. This heater may also be operated as
a vented decorative (ANSI Z21.60) product
by opening the flue damper (non-thermostat
operation only).
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system.
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
REMOTE CONTROL
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, page 24.
The wall thermostat or hand-held thermo-
stat may not be used where vented decora-
tive listing is required.
Advertisement
Table of Contents
