Capacitor; Diode - Amana RCS10DA Service Manual

Disassembly Procedures
!
WARNING
replaced.
Adjusting Interlocks
The interlock monitor, primary, and secondary switches
act as a final safety switch, protecting the operator from
microwave energy. After adjusting the interlock switch
assembly, verify wires are correctly connected.
For door fit and switch operation, switch bracket is
adjustable.
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Loosen switch bracket mounting screws.
3. Close oven door, move switch bracket toward rear of
oven until door gap is less than
4. Hold switch bracket securely for proper switch
operation and door fit, retighten screws.
5. Open oven door slowly, watching the switches. Verify
switches release in the following order.
• Primary interlock switch
• Secondary interlock switch
• Interlock monitor switch
NOTE: Adjust the switch bracket until all switches
operate in proper sequence.
6. Close the oven door slowly, watching the switches.
Verify switches activate in the following order.
• Interlock monitor switch
• Secondary interlock switch
• Primary interlock switch
7. When proper switch sequence has been achieved,
tighten the switch bracket securely.
!
CAUTION
A microwave leakage test must be preformed anytime
a door assembly is removed, replaced, disassembled,
28
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
1
/ –inch (0.5 mm).
64
16023293 Rev. 0
or adjustment of switch bracket is performed.
High Voltage Capacitor
High voltage capacitor should always be discharged by
shorting a terminal to a chassis ground. The capacitor
has a internal "shunt" resistor, but the mechanical
discharge should always be performed to avoid personal
injury.
High Voltage Capacitor Removal
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Discharge high voltage capacitor.
3. Remove and label wire leads from capacitor terminals.
4. Remove screw securing capacitor strap to bottom
plate.
5. Slide capacitor out of capacitor strap and remove

capacitor.

6. Replace capacitor and reverse procedure to
reassemble.
NOTE: When replacing H.V. components, route H.V.
1
wires at least / " / 6 mm from all grounded
4
surfaces to prevent arcing.
H.V. Capacitor
Bottom
Plate

Diode

1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Disconnect diode from high voltage capacitor and
remove screw securing diode to ground.
Bracket
H.V.
Capacitor
H.V.
H.V.
Diode
Transformer
Blower Motor
Assembly
©2004 Maytag Services