Connecting Wires To Terminals - Kenwood KDC-3031A Instruction Manual

Connecting Wires to Terminals

REMO. CONT
B
Fuse (10A)
Wiring harness
(Accessory1)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
A
Rear left output (White)/
Rear right output (Red)
FM/AM antenna Antenna Conversion Adaptor
input (ISO–JASO) (Accessory3)
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page
A –7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
KDC-W4531
A To Steering remote
B To KENWOOD disc
changer/ External optional
accessory
To connect these leads, refer to the relevant instruction manuals.
Antenna Cord (ISO)
Connect to the terminal that
is grounded when either the
MUTE
telephone rings or during
conversation.
To connect the KENWOOD
navigation system, consult
your navigation manual.
Connect either to the power
control terminal when using the
optional power amplifier, or to
P.CONT
the antenna control terminal in
ANT.CONT
the vehicle.
KDC-W4031/ KDC-W431G
W409/3031A/
3031G/309A/309G
To Steering remote
—
English
—
—
25
|