Table of Contents
Advertisement
Connecting Wires to Terminals
To USB device
USB connector (1 m)
⁄
• Do not remove the cap when you
do not use the USB cable. The
connector will cause the unit to
malfunction if it gets in touch with
any metallic part of the vehicle.
Fuse (10A)
Wiring harness
(Accessory1)
External amplifier control wire (Pink/Black)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
See next page
A-–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
8
6
4
2
7
5
3
1
Connector B
8
6
4
2
7
5
3
1
|
50
English
To External Display/
Steering remote
To "EXT.AMP.CONT. " terminal of the amplifier having the external
EXT.
CONT
amp control function.
Connect to the terminal that is grounded when either the
MUTE
telephone rings or during conversation.
⁄
To connect the Kenwood navigation system, consult your
navigation manual.
Connect either to the power control terminal when using the
optional power amplifier, or to the antenna control terminal in the
P.CONT
ANT.CONT
vehicle.
Front right output (Red)
Front left output (White)
FRONT
Rear right output (Red)
Rear left output (White)
REAR
Sub Woofer right output (Red)
SUB
Sub Woofer left output (White)
WOOFER
FM/AM antenna input
(JASO)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant
instruction manuals.
AUX input (Stereo)
Use the mini-plug which is stereo type and does not
have any resistance.
Antenna Cord
Advertisement
Table of Contents
