Connecting Wires To Terminals - Kenwood KDC-136 Instruction Manual

Connecting Wires to Terminals

Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or
during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
To front right speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery +
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
Purple
Car fuse box
–
Rear left output / Sub Woofer left output (White)
Rear right output / Sub Woofer right output (Red)
FM/AM antenna input
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
ACC
Ground wire (Black) - (To car chassis)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
15
|
English