One-Touch Edit Recording (Cd = Md /Cd = Tape) - Kenwood HM-382MD Instruction Manual

One-touch edit recording
Records all tracks in a CD with a simple operation. (All-track recording)
Records a single CD track being played from the beginning. (Single-track recording)
Be sure to put the MD recorder and cassette deck in stop mode
1
Make the preparations for recording.
CD = MD
1 Insert a disc into the MD recorder.
2 Insert disc in the CD player.
2
Check the current play mode of the CD player.
All-track recording
If it is in play mode, stop it.
3
Start recording.
÷ When the MD O.T.E. or TAPE O.T.E. key is pressed for "Single-track recording", the CD track being played is replayed
from the beginning and recording start at the same time.
÷ The recording operation can also be controlled from the main unit, by setting "REC MODE" to "CD =
"CD = = = TAPE". = =
To interrupt a recording
(Recording and playback will be
stopped.)
Note that this cassette deck cannot record onto
Metal tapes.
Note Note
(CD = MD /CD = TAPE)
STOP
MD O.T.E.
STOP
Convenient Recording Methods
CD = TAPE
1 Perform steps 1 to 3 of the procedure in
"Recording on TAPE".
2 Insert disc in the CD player.
Single-track recording
Select the desired CD track and play it.
To record other tracks, repeat steps 2 and
3 for each track.
At the end of the recording
MD recorder : Stop.
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec. has
been produced.
Do not turn power off or apply shock or impact while
"WRITING" is displayed. If the power cord is un-
plugged before "WRITING" disappears, the recorded
or edited data will be lost.
º
&
TAPE O.T.E.
= = MD<NORM>" or = =
41