Remote Controller Installation - Panasonic CS-F24DD2E5 Service Manual

10.5.3. Remote controller installation

• Be sure to turn off the main power before installing and connecting the remote controller.
(If the remote controller is connected while the power is still turned on, the remote controller displays may not appear.)
If no displays appear on the remote controller, check while referring to "If no remote controller displays appear" in "9.5.5. Test
operation".
• The remote control cable is live during use, so please be careful with it.
• Connect the indoor unit and the remote controller as shown in the illustration below.
• The remote control cable is non-polar.
• At the time of shipment from the factory, the connector cable used to connect the terminal block and connector CN1 is
disconnected. When connecting the remote controller wiring and installing the remote controller, be sure to connect the cord to
the connector CN1.
• Solder a sheathed PVC cord or cable (0.5 - 2 mm
of the accessory remote control cable (10 m).
* PVC round cabtire cord
* 600V PVC-insulated PVC sheathed round cable
* 600V PVC-insulated PVC sheathed flat cable
• Remove the remote controller lower case.
(Insert a flat-tipped screw driver or similar 2 to 3 mm into one of the gaps at the bottom of the case, and then twist the screw
driver to open. [Refer to the illustration below.])
Be careful not to damage the lower case.
• Secure the lower case to the wall or outlet box.
(Refer to the illustration below for the embedded and exposed positions for remote control cable.)
Remote controller wiring
Extending the remote control cable
2
NOTE The maximum possible length for the remote control cable is 200 m.
Remote controller installation procedure
) with specifications among those given below to the remote controller end
67
IEC 502
IEC 227-4
IEC 227-4