Jeep 2014 Grand Cherokee User Manual page 122

ELECTRONICS
6. Return to the vehicle and press the programmed HomeLink
(holding the button for two seconds each time). If the device is plugged in and
activates, programming is complete.
NOTE:
If the device does not activate, press the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the
HomeLink ® button you wish to program while keeping the HomeLink
light in view.
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
5. Press and hold the programmed HomeLink
light. If the indicator light stays on constantly, programming is complete and the
garage door (or device) should activate when the HomeLink
6. To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
Using HomeLink®
To operate, press and release the programmed HomeLink
now occur for the programmed device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting, etc.,). The hand-held trans-
mitter of the device may also be used at any time.
120
buttons, repeat each step for each
®
button you want to program
®
button and observe the indicator
®
®
® buttons, repeat each step for each
® button. Activation will
® button twice
® indicator
®
® has received the
button is pressed.