Table of Contents
Advertisement
00566A-D-R3_14~35 8/31/04 10:28 AM Page 31
Allow you to setup the Audio device and sound status
depending on the audio system in use.
1
2
3
4
5
NOTE
Downloaded From Disc-Player.com Toshiba Manuals
Setting Up the Audio
Options
With the unit in Stop mode, press the
MENU button on the remote.
Select "Setup" using †... buttons, then
press the √ or OK button.
Select "Audio" using †... buttons, then
press the √ or OK button. Audio setup
menu will be displayed.
DVD-RAM(VR)
System
Language
Audio
Video
Parental Control
MOVE
OK
RETURN
EXIT
Use †... buttons to select the desired
sub menu and press the OK or √ button.
DVD-RAM(VR)
Digital Output
: PCM
PCM
DTS
: Off
Bitstream
Dynamic Compression : On
MOVE
OK
RETURN
EXIT
Use the †... buttons to select the
desired item. Then press the √ or OK
button.
Press the RETURN or œ button to return
to the previous menu. Press the MENU
button to exit the menu.
Audio Options
Digital Output
1. PCM :
Select this when you have no equipment that
can decode Dolby Digital (or MPEG-2) signal.
When you play Dolby Digital (or MPEG-2)
sound track, the digital output are
converted to PCM Stereo.
2. Bitstream : Output Dolby Digital (or MPEG-2) audio as
NOTE
DTS
Setup
√ √
1. Off :
√ √
√ √
√ √
√ √
2. On :
NOTE
Audio
√ √
Dynamic Compression
√ √
√ √
Dynamic Range Compression : This is only active
when a Dolby Digital signal is detected.
- On : When the Movie-soundtracks are played at low
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
- Off : You can enjoy the movie with standard Dynamic
Range.
bitstream. Select this when your AV
receiver or AV amplifier have Dolby Digital
(or MPEG-2) Decoder.
Digital output setting is equally applied to
both Dolby Digital and MPEG-2 audio.
LPCM sound track is always outputted as
PCM. It has no relation with Digital Output
setting.
Be sure to select the correct Digital
Output or you will hear no sound or loud
noise.
Doesn't output DTS signal.
Select this when your AV receiver or AV
amplifier does not have DTS decoder.
Outputs DTS Bitstream via digital output
when you play DTS track.
Select this only when your AV receiver (or
AV amplifier) have DTS decoder.
When DTS soundtrack is played, sound
does not output from Analogue Audio
Output.
English -
31
Advertisement
Table of Contents
