Resharpening The Cutting Tool - Dolmar MS-3202 Original Instruction Manual

– Firmly hold the clutch case by your left hand, as illustrated.
– Slowly pull the starter grip until resistance is felt and continue with a smart
pull.
– Do not pull out the starter rope to its full extent and do not allow the starter
handle to be retracted without control, but ensure that it is retracted slowly.
– Repeat the starting operation until initial ignitions are heard.
– When the engine start, return the choke lever to "
choke lever will return to "
operated and the throttle is opened.
– Run the engine for approximately one minute at a moderate speed before applying full throttle.
Note: – If the starter handle is pulled repeatedly when the choke lever remains at "
excessive fuel intake.
– In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also,dry the
electrode section of the spark plug.
Caution during operation:
If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 /min or more. Never operate the engine at a
higher speed than required and at an approximate speed of 6,000 - 8,000 /min.
Starting the warm engine
– Same as adove, except without moving the choke lever (choke lever remains in the position "
STOPPING
– Release the throttle lever (6) fully, and when the engine rpm has lowered,
push the I-O switch (1) to "O" position the engine will now stop.
– Be aware that the cutting head may not stop immediately and allow it to slow
down fully.
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
The cutter blade or the nylon cutting head should not run when the control lever is fully released. If necessary, adjust the idle rpm using the idle
adjusting screw.
Checking the Idling speed
– Idle speed should be set to 2,600 /min.
If necessary correct it by means of the idle screw (the blade or the nylon
cutting head must not turn when the engine is on idle).
Screwing in the screw (1) will cause an increase in the engine speed,
whereas backing off the screw will reduce the engine speed.

RESHARPENING THE CUTTING TOOL

CAUTION : The cutting tools mentioned below must only be resharpened by an
authorized facility. Manual resharpening will result in imbalances of
the cutting tool causing vibrations and damage to the equipment.
– cutter blade (star blade (4 teeth), eddy blade (8 teeth))
An expert resharpening and balancing service is provided by Authorized Service
Agents.
NOTE : To increase the service life of the cutter blade (star blade, eddy blade) it
may be turned over once, until both cutting edges have become blunt.
". Please note that the
"position automatically when the throttle lever is
" position, the engine will not start easily due to
Idle speed
14
".
Full speed