Cd/Mp3/Wma (Cde-153Bt Only); Playback; Repeat And Random Play; Searching For Cd Text - Alpine CDE-153BT Owner's Manual

CD/MP3/WMA
(CDE-153BT only)
Rotary encoder

/ENTER
/SOURCE

/ II


Playback

1
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Note
• When a disc is already inserted, press VSOURCE to switch to the
DISC mode.
2
While playing back MP3/WMA, press  or  to select the
desired folder.
3
Press  or  to select the desired track (file).
Pressing and holding  or  will fast backward/fast
forward track continuously.
4
To pause playback, press .
Pressing  again will resume playback.
5
To eject the disc, press .
Notes
• Do not remove a CD during its eject cycle. Do not load more than one
disc at a time. A malfunction may result from doing either.
• Three-inch (8 cm) CDs can not be used.
• Any file protected by DRM (Digital Rights Management) copy
protection, cannot be played back on this unit.
• The track display for MP3/WMA data playback is the file numbers
recorded on the disc.
• The playback time may not be correctly displayed when a VBR
(Variable Bit Rate) recorded file is played back.
12
-EN

5

4
Preset buttons
(1 through 6)

Repeat and Random Play

1
During playback, Press z 4 or x 5 repeatedly until the
setting appears.
RPT ONE:
Track/file is played back repeatedly.
*
RPT FOLDER :
Files in a folder are played back repeatedly.
*
MIX FOLDER :
Files in a folder are played back randomly.
MIX ALL:
All files in the disc or Flash Memory are played back randomly.
* When MP3/WMA files are played back.
2
To cancel repeat or M.I.X. play, select (off) with the above
procedure.
Notes
• a indicator lights up during repeat play mode.
• s indicator lights up during random play mode.

Searching for CD Text

On discs utilizing CD Text, songs can be searched and played by using
their recorded titles. For discs without CD Text, searches are made using
the track numbers associated with each song.
1
Press ENTER during play.
This will set the search mode, and the "" indicator lights up.
2
Turn the Rotary encoder to select the desired track, and
then press ENTER.
This will play the selected track.
Notes
• Press any of the preset buttons (1 through 6) during a search to skip
over a calculated percentage of tracks. For details, refer to "Direct
Search Function" on page 32.
• Press t in the search mode to cancel. Or, the search mode is canceled
if no operation is performed for 60 seconds.
• When CD Text Search is made during M.I.X. play, the M.I.X. play
mode will be canceled.