Ec Declaration Of Conformity - Flymo Minimo Original Instructions Manual

If any part is found to be defective due to faulty manu-
facture within the guarantee period, Husqvarna
Outdoor Products, through its Authorised Service
Repairers will effect the repair or replacement to the
customer free of charge providing:
(a) The fault is reported directly to the Authorised
Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or faulty
adjustment by the user.
(d) The failure has not occurred through fair wear and tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna Outdoor Products.
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Failures due to the following are not covered, therefore
it is important that you read the instructions contained
in this Operator's Manual and understand how to oper-
ate and maintain your machine:
I, the undersigned M. Bowden of Husqvarna
Outdoor Products, Aycliffe Industrial Park,
NEWTON AYCLIFFE, Co. Durham. DL5
6UP. Certify that the Product:-
Category........ Electric Lawn Trimmer
Make.............. Husqvarna Outdoor
Products
Conforms to the specifications of Directive
2000/14/EEC
Type of Cutting Device...... Plastic Cutter
Identification of Series....... See Product Rating Label
Conformity Assessment Procedure....ANNEX VI
Notified Body..................... I.T.S.. Cleeve Road, Leatherhead,
Other Directives:-...............98/37/EEC, 89/336/EEC, 73/23/EEC
& applicable standards:- EN786, IEC60335-1, EN60335-2-91,
EN61000-3-2, EN61000-3-3, EN55014-1, EN55014-2
Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice.
5119359-06
Guarantee & Guarantee Policy

EC Declaration of Conformity

I, the undersigned M. Bowden of Husqvarna
Outdoor Products, Aycliffe Industrial Park,
NEWTON AYCLIFFE, Co. Durham. DL5
6UP Certify that a sample of the above
product has been tested using directive
81/1051/EEC as a guide. The maximum A-
weighted sound pressure level recorded at
operator position under free field semi ane-
choic chamber conditions was :-
Surrey, KT22 7SB. England
Husqvarna Outdoor Products
Telephone - (00) 44 870 609 1901 Fax - (00) 44 870 609 1902
Failures not covered by guarantee
* Replacing worn or damaged plastic cutters
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and recommenda-
tions contained in this Operator's Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as wear-
ing parts and their life is dependent on regular
maintenance and are, therefore not normally sub-
ject to a valid warranty claim: Plastic Cutters,
Cutting Head, Electric Mains cable.
Caution!
*
Husqvarna Outdoor Products does not accept lia-
bility under the warranty for defects caused in
whole or part, directly or indirectly by the fitting of
replacement parts or additional parts that are not
either manufactured or approved by Husqvarna
Outdoor Products, or by the machine having been
modified in any way
Type................................................................... Minimo
Width of Cut....................................................... 28cm
Speed of Rotation of Cutting Device.................. 7,500 RPM
Guaranteed sound power level.......................... 94 dB (A)
Measured Sound Power Level........................... 94 dB (A)
Level................................................................... 81.6 dB (A)
Value................................................................... 2.12 m/s
Weight................................................................. 5.4 kg
Aycliffe Industrial Park
NEWTON AYCLIFFE
Co.Durham DL5 6UP
ENGLAND
I, the undersigned M. Bowden of
Husqvarna Outdoor Products, Aycliffe
Industrial Park, NEWTON AYCLIFFE, Co.
Durham. DL5 6UP Certify that a sample
of the above product has been tested using
ISO 5349 as a guide. The maximum
weighted root mean square value of vibra-
tion recorded at operator's hand position
was:-
Newton Aycliffe, 08/02/2006
Research & Development Director
2
M. Bowden,