Access Control - Sapido BR261c User Manual

WPA-Mixed
802.1x Authentication
Radius
Personal (Pre-Shared
Key)

Access Control

Please refer Wireless Access Control
WPS
This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using
this feature could let your wireless client atomically synchronize it's setting and
connect to the Access Point in a minute without any hassle. SAPIDO BR261c could
support both Self-PIN or PBC modes, or use the WPS button (at real panel) to easy
enable the WPS function.
PIN model, in which a PIN has to be taken either from a sticker label or from the
web interface of the WPS device. This PIN will then be entered in the AP or client
WPS device to connect.
PBC model, in which the user simply has to push a button, either an actual or a
virtual one, on both WPS devices to connect.
BR261c WPS only support no encryption and WPA2
Please follow instructions below to enable the WPS function.
Setup Wireless LAN with WPS PIN :
•
◦ Get the WPS PIN number from wireless card and write it down.
communication, so it can communicate safer than
WEP key which uses single encryption key for
long time. "AES" is harder to decode comparing
to "TKIP", so it can say tougher encryption
scheme than "TKIP"
Support WPA and WPA2 at the same time
For radius server authentication
* If you configure Pre-Shared Key as
"Hexadecimal in 64 digits", please select "Hex
(64 characters) ".
* If you configure encryption key in "8 to 63
letters in half-width alphabets and numbers",
please select "Passphrase