Central Pneumatic 67696 Set Up And Operating Instructions Manual page 12

ASSEMBLING THE RUBBER FOOT AND
WHEELS
See Figure 3.
Mount the rubber feet as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure it in position.
Mount the wheels as shown in figure.
Tighten firmly with an open-end wrench (not included)
to secure the wheels in position.
ASSEMBLING THE HANDLE
See Figures 4 - 5.
Lower the handle onto the compressor body, as shown
in Figure 4.
Line the holes of the handle with the ones on the slots
of the compressor. Then insert the two knobs and
tighten firmly to secure the handle in position (Fig. 5).
ASSEMBLY
HOLE OF
THE ANDLE
12
WASHER WASHER
NUT
NUT NUT
WASHER(s)
WHEEL
SCREW
HANDLE
KNOB
RUBBER
FOOT
WASHER
SCREW
Fig. 3
Fig. 4
Fig. 5