Kenmore 625.3882 Owner's Manual page 6

[i:ii:ii:ii:_i:i:ii:_i:i:ii:_i:i:ifSECTION 1 l:oii:ii:_i:i:ii:_i:i:ii:_i:i:ii:_i:]
WATER SOFTENER START UP
C. PROGRAM THE TIMER
signal light adjust
display
_ALT SIGNAL
LEVEL LEVEL
UltraSoft 200
salt level adjust
UP button SELECT button
/ /
RECHARGE _
Customer Assistance
TONIGHT
_ 1-800-426-9345
RECHARGE www.KenmoreWatercom
NOW
LOW
SALT
/
ON/OFF-HOLD button
(Recharge Tonight- Now)
When the transformer is plugged in, the model code
SR27, and a test number (example: k20) show in the
face plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
@
DOWN button
J
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the dis-
play reaches 1 using the DOWN button, or the high-
est hardness setting using the UP button.
_SET PRESENT TIME OF DAY
S,-2-,'
20 L
,,,,,,,,M
I I_- 'UI_I
PRESENT TIME
Notes:
If SR - - shows in the display, press the UP [] or-
DOWN [] button until SR27 shows. Then, press
the SELECT button to set, and change to the flashing
PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than SR27
shows, see page 5-3 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
If the words PRESENT TIME do not show in the dis-
play, press the SELECT button (FIG. 2) until they do,
or see the previous notes.
• Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
I I, |- |--| PM
'30 I
PRESENT TIME
J J'30 I
PRESENT TIME
Each press of the UP /DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
1-3