Program The Timer; Set Present Time Or Day - Kenmore 625.38306 Owner's Manual

Display UP Button
REGENERATION Button
SELECT Button
DOWN Button
FIG. 24
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code
(S 25) and a test number (example: J1.1) show in the
face plate. This will display for four (4) seconds. Then,
12:00 PM and the words SET TIME begin to flash.
NOTE: If "- - - -" shows in the display, press the
UP or DOWN button until S 25 shows in the dis-
play. Then, press the SELECT button to set, and
change to the flashing SET TIME display.
2. To check the model code, unplug the transformer at
the wall outlet and plug in again. If other than S 25
shows, refer to the Troubleshooting Section.
SOUND "BEEPER": A "beeper" sounds while press-
ing buttons for timer setup. One beep signals a
change in the face plate display. Repeated beeps
mean the timer will not accept a change from the but-
ton you have pressed, telling you to use another but-
ton. For example, while setting the hardness, the
beeper sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness set-
ting using the UP button.
CODE 1
S c:,l
ISET I
T, M E_ _--I't--I1--t
L- .L! L! pM
FIG. 25
SET PRESENT TIME OF DAY
If the words SET TIME do not show in the display, press
the SELECT button until they do show in the display.
Press the UP or DOWN buttons to set the present time.
Press UP to move the display ahead; press DOWN to
move the time backward. If the present time is between
noon and midnight, be sure PM shows. If the present
time is between midnight and noon, be sure AM shows.
Each press of the UP or DOWN buttons changes the
time by one (1) minute. Holding the buttons in changes
the time 32 minutes each second.
SET I
i I,[ I_-t
I "riME
-i.-! 0 pM
t t.-IL-
! !._-i0
FIG. 26
Questions? Call The Kenmore Water Line 1-800-426-9345
18