Operating Video Components - JVC RX-8030VBK Instructions Manual

Operating Video Components

IMPORTANT:
To operate JVC's video components using the supplied remote
control:
• You need to connect JVC's video components through the AV
COMPU LINK jacks (see page 40) in addition to the connections
using cables with RCA pin plugs (see pages 11 to 13).
• Some JVC's VCRs can accept two types of the control signals—
remote code "A" and "B." Before using this remote control, make
sure that the remote control code of the target VCR is set to code
"A."
• When another JVC's VCR is connected to the VCR 2 or VIDEO
terminals, set its remote control code to code "B." (This remote
control cannot emit the control signals of code "B.")
• When using the remote control, aim the remote control directly at
the remote sensor on each component, not on the receiver.
• When you press one of the source selection buttons, the
operation mode appears on the display window.
Buttons
VCR 1
DVD or DVD MULTI
TV/DBS
CONTROL (repeatedly)*
* By pressing CONTROL repeatedly, you can select
"VCR 1," "TAPE," "CDR" or "CDDSC" as the source.
When you press one of the buttons listed above, the
remote operation mode appears on the display window
for about two hours.
44
Indications
VCR 1
DVD
TV
VCR 1 TAPE
CDDSC CDR
VCR
You can always perform the following operations:
VCR 1 : Turn on or off a VCR.
After pressing VCR 1 (or selecting " VCR 1" by pressing
CONTROL repeatedly), you can perform the following operations
on a VCR:
1 – 9, 0: Select the TV channels on a VCR.
3:
Start playing.
REW: Rewind a tape.
FF:
Fast wind a tape.
7:
Stop playing or recording.
8: Pause playing. To resume, press 3.
REC PAUSE: Enter recording pause by pressing this button.
To start recording again, press this button then 3.
CH +/–: Change the TV channels on the VCR.
Note:
You can use either VCR 1 or the CONTROL to activate the buttons
listed above. If you press one of the source selection buttons, the
playing source also changes. On the other hand, pressing the control
button does not change the playing source.
DVD player
After pressing DVD or DVD MULTI, you can perform the following
operations on a DVD player:
3:
Start playing.
4:
Return to the beginning of the current (or previous) chapter.
¢:
Skip to the beginning of the next chapter.
7:
Stop playing.
8: Pause playing. To resume, press 3.
After pressing DVD or DVD MULTI,
these buttons can be used for the DVD
menu operations.
Note:
For detailed menu operations, refer
to the instructions supplied with the
discs or the DVD player.
TV
You can always perform the following operations:
TV
: Turn on or off the TV.
TV VOL +/–: Adjust the volume.
TV/VIDEO:
Set the input mode (either TV or VIDEO).
After pressing TV/DBS, you can perform the following operations
on a TV:
CH +/–: Change the channels.
1 – 9, 0, 100+: Select the channels.
RETURN: Alternate between the previously selected channel
and the current channel.
2 3
MENU
4 5 6
ENTER
8