Energy Saving Mode - Toshiba e-studio 5520c Quick Start Manual

Chapter 1 PREPARATIONS

Energy saving mode

This equipment supports two energy saving modes; the Automatic Energy Save mode and the Sleep mode.
Automatic Energy Save
The equipment enters the Automatic Energy Save mode automatically after a specified period of time
During this mode, "Saving energy – Press START button" appears on the touch panel.
Sleep mode
The equipment enters the Sleep Mode automatically after a specified period of time
message on the touch panel goes off and the [ENERGY SAVER] button lights in green.
These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax data or E-mails. They are
also cleared by pressing the [START] button.
*1 This period is set at 3 minutes for e-STUDIO5520C, 5 minutes for e-STUDIO6520C and 10 minutes for e-STUDIO6530C by factory default.
*2 This period is set at 30 minutes by factory default.
Refer to the MFP Management Guide for changing the default settings noted above.
Note
For the European version
Contact your service representative to change the default settings noted above.
The equipment can also be made to enter the sleep mode manually by means of the following procedure. In this mode,
the message on the touch panel goes off and the [ENERGY SAVER] button lights in green.
Press the [ENERGY SAVER] button on the control
panel.
To cancel the energy saving mode
Press the [START] button on the control panel. The sleep mode is cleared and the equipment will be ready for copying.
The sleep mode can be also cleared by pressing any button of [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and
[FAX].
2
since its last use.
*
since its last use. In this mode, the
*2