Chapter 1 PREPARATIONS
Description of Each Component
This section describes the names and operations of the components and options.
Front / Right side
9
10
8
1.
Reversing Automatic Document Feeder
The stack of originals is scanned one sheet at a time. Both
sides of the originals can be scanned. A maximum of 00
originals (80 g/m
or 0.2") can be placed in one go. (The maximum number
of sheets that can be set may vary depending on the
media type of the originals.)
2.
Operator's manual pocket (back side)
Keep the manual in this pocket.
3.
Duplexing unit cover
Open it when paper jams occur in the duplexing unit.
4.
Duplexing unit
Use this unit for printing on both sides of the paper. Open
it when paper jams occur.
5.
Bypass tray
Use this to perform printing on special media types such
as OHP film, waterproof paper, etc.
6.
Paper feed cover
Open this cover when releasing paper misfed in the
drawer feeding area.
2
2
7
4
or 20 lb. Bond) (or stack height mm
2
1
3
13
5
6
7.
Paper size indicator
8.
Drawer
A maximum of 50 sheets (80 g/m
sheets (05 g/m
placed in one go.
9.
Front cover
Open this cover when replacing the toner cartridge or
releasing paper misfed in the Bridge Unit.
10.
Main power switch
Use this switch to turn the power of the equipment ON or
OFF.
&P.22 "Turning Power ON/OFF"
11.
USB terminal (4-pin)
Use this terminal when connecting this equipment to a PC
with a commercially available USB cable.
12.
Network interface connector
Use this connector when connecting this equipment to a
network.
13.
Network interface connector cover
11
12
or 20 lb. Bond) or 500
2
or 28 lb. Bond) of plain paper can be
2