Sim Personalisation - Panasonic G600 Service Manual

TEST AND MEASUREMENT
7.7

SIM Personalisation

7.7.1 Introduction
SIM personalisation will limit the use of G600 to a single SIM, a SIM supplied by one Networ
Provider or a SIM purchased by a company (corporation). If a personalised G600 contains a SI
different source it will display the message "SIM ERROR" when switched on. This personalisat
sometimes referred to as SIM lock or SIM latch.
7.7.2 Testing
To test a personalised G600, when the user has not supplied the SIM, a SIM configured for te
SIM or soft SIM) should be used. The mobile will recognise that the SIM is for testing purpo
normal.
7.7.3 Personalisation Function
Personalisation is activated during manufacture and then enabled at a later stage. Enabling/
by entering a special key sequence immediately after power on. Once the enable/disable menu
possible to select the type of personalisation. When personalisation is enabled it is only p
mobile contains an illegal SIM and the sixteen digit Control Key (CK) is known. When enabled
from the user and cannot be read, for security reasons.
There are two special key sequences to enter the enable/disable menu:
Key sequence
7 4 6 B B
5 2 8 2 4 B B
7.7.4 Disabling Procedure
1. F 7 4 6 B B or 5 2 8 2 4 B B
2. F e to point
at;
"SIM" for SIM Personalisation
"Network" for Network Personalisation
"Subnetwork" for Subnetwork Personalisation
"SP" for Service Provider Personalisation or
"Corporate" for Company Personalisation
3. F B
4. F the 16 digit Control Key
5. F B
6. F the 16 digit Control Key
7. F B
The display will confirm which type of Personalisation has been disabled.
Issue 1
Revision 0
Notes
Can only disable personalisation
Can both enable and disable personalisation
Section 7
7 - 22
etwork/Service
is from a
G600 is
oses (e.g. test
y and operate as
ng is available
n it is
to disable it if the
is withheld
600-0707
MCUK980101C8
Service Manual