Programming The Phone System - NEC Xen IPK Installation Manual

June 2004
S 6
E C T I O N
P
ROGRAMMING THE
P S
HONE YSTEM
10 - Chapter 2
To set up the phone system to support digital voice messaging, complete
the procedures in this section.
The following table describes the key functions on individual stations.
Key Function
FEATURE Return to preceding page
RECALL Advance to next page
CONF Go to next selection
REDIAL Enter pause, hyphen, *, or #
SPEAKER Exit programming mode
ANSWER Go back one level
TRANSFER Save settings
HOLD Clear settings
* Move left
# Move right
To enter programming mode
1 From port 01 or 02, press the FEATURE key.
2 Press the HOLD key.
3 Dial #0*.
To assign interface slot number
Memory block 7-1 assigns the slot number on the phone system that
contains the voice messaging system board.
1 Press the LK7 key.
2 Press the LK1 key.
3 Enter the cabinet number and press # .
4 Enter the slot number for the voice messaging system board.
5 Press the RECALL key twice to advance to page 3.
6 Press the LK4 key.
7 Press the TRANSFER key to save the slot assignment and advance to
the next slot.
8 Press the ANSWER key twice to exit slot assignment.
NEC Business Solutions Ltd
Setting Up the System