Table of Contents
Advertisement
Connections
Connection to a TV (Progressive)
1
Using component video cables (not supplied), connect the
COMPONENT VIDEO OUT terminals on the rear of the DVD
player to the COMPONENT IN terminals of your TV.
2
Using the audio cables, connect the AUDIO (red and white)
OUT terminals on the rear of the DVD player to the AUDIO (red
and white) IN terminals of your TV.
Turn on the DVD player and TV.
3
Press the input selector on your TV remote control until the
Component signal from the DVD player appears on the TV
screen.
4
Set the Video Output to HDMI/COMPONENT(P-SCAN) in the
Display Setup menu. (See pages 64 to 65)
You can use the V.OUT button to change the Video Output
mode. (See page 14)
To see the progressive video output,
- Consult your TV User's Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan settings
in the TV's menu system.
- Depending on your TV, the connection method may differ from the illustration above.
Note
- What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method.
Progressive scanning method provides better and clearer picture quality.
RED
Audio Cable
RED
WHITE
ENG-17
RED
BLUE
GREEN
WHITE
Component cable
(not supplied)
RED BLUE GREEN
Advertisement
Table of Contents
