Bundled Software For The Server; Nec Esmpro Agent - NEC Express5800/R320c-E4 Installation Manual

Chapter 2 Installing the Bundled Software
1.

Bundled Software for the Server

The provided "NEC EXPRESSBUILDER" DVD contains "NEC ESMPRO Manager" for managing the NEC
Express5800/ft series. This utility monitors the status of Express5800/ft server.
1.1

NEC ESMPRO Agent

NEC ESMPRO Agent is a utility to monitor the operating status, the configuration information, the failure
occurrence status of hardware and software on the NEC Express5800/ft series. When it detects some problems,
it sends messages to the computer in which the NEC ESMPRO Manager is installed.
NEC ESMPRO Agent is required to be installed on the log server by users.
In order for NEC ESMPRO Agent to operate, it is necessary to configure the settings according to your
environment. See the User's Guide (NEC/esmpro_sa/doc/lnx_esm_users_e.pdf) included in the ft Server
Control Software Install DVD.
NEC ESMPRO Agent is stored in the ft Server Control Software Install DVD.
Described below are procedures to configure the ft Management Appliance as the log server. If you use any
other server as the log server, configure that server in similar way.
64
Express5800/R320c-E4, R320c-M4 Installation Guide (VMware)
Note
See Chapter 2 (3. Steps for Configuring the Log Server) for the log server.
Note
NEC ESMPRO Agent is to be installed on the log server of ft Server Control Software. It
monitors features related to ft Server Control Software. It does not monitor the hardware of
the ESXi host itself nor VMware.
1. Bundled Software for the Server