Kenmore 15/I649 Instructions Manual page 28

emove arm cover plata to oi] points indicated at top of
aehine head To remove cover plate, take disc out from "
achine, remove top screws and lift cover
Fig B
_ay be necessary to clean the shuttie area occasionally
Raise the needle bar to its highest 3 Clean the shuttle race of any lint or
point and remove bobbin case small particles of thread with a smatl
Push levers sideways from the shuttle brush
assembly and lift shuttle race cover 4 Put a drop of oil on the center pin of the
and shuttle out by the center pin shuttle and on shuttle race (see arrows)..
_8
d
Shuttle Assembly