Customizing Alarm Handling; Figure 6-4 Multi Options For Video Delivery Options During An Alarm - Honeywell Rapid Eye Operator's Manual

Customizing Alarm Handling

Document 800-02951V3 Rev A
11/09
1. Open the View menu, select Options and then click Alarm Handling to display the
Alarm Handling Options dialog box.
2. Select your options, as needed. Click OK (see
Options for alarms can be customized as described below.
Figure 6-4 Multi Options for Video Delivery Options During an Alarm
Alarm Handling Options
Run Live Alarm Session on Alarm. Running a live session while an alarm is pending
causes live video of all cameras at a site to be displayed full screen. Receiving an alarm
during an alarm session does not open a live alarmed session (see
on page 84).
Beep on Alarms. Makes the operator's PC produce and repeat a short, pitched, electronic
tone when a Multi-Media unit reports an alarm. An operator can use this feature even if the
PC does not have speakers or a sound card. The alarm bell icon
when Beep on Alarms is disabled.
Launch Retrieval on Selection from Alarm List. It may be more interesting for the
operator to retrieve video from the time of the event, than to view live video from the site.
The option enables you to start a retrieval session from the time of the alarm, by selecting
an alarm from the alarm list in the live alarmed session (see
disabled by removing the checkmark.
Automatically Acknowledge (ACK) Alarms. During a live alarmed session, makes the
small alarm bell button (
Figure 6-7 on page 84). The small alarm bell button is not the same as the large alarm bell
icon (illustrated in Figure 6-2); clicking the large icon only stops the beeping of the PC.
Rapid Eye Remote View Operator Guide
Figure
) acknowledge all alarms from that site (see
6-4).
Live Alarmed Session
(Figure 6-2) still vibrates
Figure 6-5). The option can be
Figure 6-5 and
79