Sony Bravia KDL-60R510A Operating Instructions Manual page 54

Condition
No sound / Noisy sound
No sound but good
picture
Audio noise
No audio or low audio
with Home Theater
System
No color / Irregular
picture
BRAVIA Sync
Cannot find connected
BRAVIA Sync HDMI/
MHL device
Second A/V receiver is
not listed on the BRAVIA
Sync Device List
PC connection
No picture / No signal
Poor Picture
54
Explanation/Solution
• Check the volume control.
• Press MUTING or VOL + so that "Muting" disappears from the
screen (see page 20).
• Set Speakers to TV Speakers in the Sound settings (see page
38). If it is set to Audio System, sound is not output from the TV's
speakers regardless of the TV's volume control.
• When using HDMI input with Super Audio CD or DVD-Audio,
DIGITAL AUDIO OUT (OPTICAL) may not provide an audio
signal.
• When tuned to a digital channel with Alternate Audio, the
broadcaster may not be broadcasting your preferred Alternate
Audio language. Press OPTIONS, highlight and select Alternate
Audio, and change the Alternate Audio language (see page
38).
• Make sure that the antenna is connected using a 75-ohm coaxial
cable (not supplied).
• Keep the antenna cable away from other connecting cords.
• To avoid TV interference, make sure to use an undamaged
antenna cable.
• Set Speakers to Audio System in the Sound settings (see page
38).
• Set Audio Out to Fixed in the Sound settings (see page 39).
• Verify that the Video/Component Selection (see page 47) is set
to the current input type in use. We suggest leaving this setting to
Auto.
• Make sure that the BRAVIA Sync Control is set up on both the
TV and the optional device compatible with BRAVIA Sync.
• Only one A/V receiver may be used with the BRAVIA Sync and
BRAVIA Sync Control functions at one time (see page 48).
• Confirm the PC is correctly connected to the TV with the HDMI
IN.
• Ensure the output signal from the PC is one of the formats listed
on page 50.
• Turn the PC off. Confirm the PC connection and restart the PC.
Plug-and-play will auto-detect the TV and correctly set up PC
timing.
• Verify the PC is not in standby or hibernation mode.
• Adjust the resolution (see page 50).