Panel Mounting - Raymarine A50 Installation Instructions Manual

Attaching the display to the bracket
Having installed the mounting bracket, the display unit can now be
attached to the bracket.
To attach the display to the bracket:
1. Release the locking mechanism, by turning the lever
anticlockwise.
2. Place the display unit onto the mounting bracket.
3. Move the locking lever down and clockwise until a positive 'click'
is felt. The display unit is now secured to the mounting bracket.
4. Attach the power cable and if applicable, the sonar and
ng
SeaTalk cables to their respective connectors on the rear of the
unit.
5. Tilt the unit to the required viewing angle and lock in position by
moving the locking lever towards you until a positive "click' is felt.
The display is now locked in position.
You can change the viewing position at any time, by releasing the
locking lever backwards until a positive 'click' is felt, move the unit to
the new position and moving the locking lever forward until a posi-
tive 'click' is felt.
Chapter 4: Location and mounting
4.4

Panel mounting

Requires the optional panel mounting kit.
D11010-1
To panel mount the display unit:
1. Check the selected location for the unit.
Take care that there are no cables or equipment behind the
mounting surface that can be damaged.
Ensure adequate clearance for cable connections to the rear
and the chart card door to the left.
2. Use self-adhesive tape to attach the mounting template in the
required position. Ensure that it is level.
self adhesive
side
D11012-1
35