Two Vcrs For Tape Editing - Sony KDF-E42A10 Service Manual

Two VCRs for Tape
Editing
Using
S VIDEO jacks?
See page 20.
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.
VCR (playback)
If you connect two VCRs, you can record from one VCR to the other while
using your TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Use an A/V cable to connect the playback VCR's A/V output jacks to
the recording VCR's A/V input jacks.
2
Use an A/V cable to connect the recording VCR's A/V output jacks to
the TV's A/V input jacks.
A/V cable
✍
To perform tape editing, set the TV to the video input intended for
playback by pressing TV/VIDEO on the remote control.
✍
You may need to change the video input on your VCR. See your
VCR's operating manual for instructions.
✍
If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the VIDEO cable (yellow) on your
combined A/V cable.
Using an S VIDEO cable, connect the playback VCR's S VIDEO
OUT jack to the recording VCR's S VIDEO IN jack. S VIDEO does
not provide audio, so audio cables must be connected to provide
sound.
✍
You cannot record signals from equipment connected to the Y
P /C P /C input.
B B R R
Rear of TV
VCR (recording)
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
AUDIO-R
AUDIO-L
VIDEO
A/V cable
Connecting the TV
1 3
VIDEO IN
37