To Set The Clock - Kenmore 911.93501 Use And Care Manual

I ÷
J
OPBMTiON
OvenCon ol, Clock, and Timer(cont.)
÷
If the display flashes an "F" followed
by a number and beeps continuously,
you have a function errorcode.
Note the number after the "F." Turn
the oven controlknob to the OFF
position. Disconnect all power to the
range for at least 30 seconds and
retry the oven operation. If the "F"
displays during a self-clean cycle,
check the oven door latch. Make sure
the latch is moved to the right as
far as it will go. Turn the OVEN
CONTROL KNOB to the OFF
position. Allow the oven to cool 1 hour
and retry the oven operation. If the
problem repeats, call for service,
Advise the technician what the
flashing code was.
When the power to your range is
turned on for the firsttime, or if you
experience a power failure, the
display will flash "PF." By touching
the CLOCK pad, the display will flash
"12:00."Touch the CLOCK pad again
and follow the instructions to set the
clock.Any operation set beforea
power failure will need to be reset.
The oven will automatically shut off
if it has been left on for more than
12 hours.
To deactivateor reactivatethe
automaticshutoff,touchand hold the
MIN UP and DOWN arrowpads for
about 4 seconds,
÷
11