Connecting The Receiver - Sirius Satellite Radio ST2C STARMATE REPLAY User And Installation Manual

Once the antenna cable is routed through the
vehicle, and you are satisfied with the cable
routing, peel the yellow protective material from
RUBBER ANTENNA
CABLE COVER/TAIL
VEHICLE
MOUNTING SURFACE
the adhesive strip and adhere the adhesive strip
to the rubber antenna cover/tail. Next peel the red
protective material from the adhesive strip and
press the rubber antenna cable cover/tail firmly
into place on the vehicle.
Double check that the location of the antenna and
rubber antenna cable cover/tail are correct, and
continue to press firmly down on the rubber
antenna cable cover/tail for another 30 seconds.
12
Note: At room temperature (68 degrees), maximum
adhesion usually occurs within 72 hours. During
this period, avoid car washes and other contact with
the antenna and rubber antenna cable cover/tail.

Connecting the Receiver

Connect the antenna and cigarette lighter power
adapter to the Receiver to complete the
installation. The illustration below shows the
location of the antenna and power connectors on
the Receiver.
ANTENNA
FM OUT
AUDIO OUT
POWER
Plug the cigarette lighter power adapter cord into
your vehicle's cigarette lighter, and turn the Receiver
On by pressing the power button. Once you have
verified that Receiver has powered on, you can
proceed with activating your SIRIUS subscription.
ST2C Starmate Replay User and Installation Guide