Table of Contents
Advertisement
PROTECTIVE MATERIAL
(RED SIDE)
ADHESIVE
STRIP
ANTENNA
CABLE
RUBBER ANTENNA
CABLE COVER/TAIL
Connect the rubber antenna cable cover/tail to the
antenna cable, making sure that the strain-relief
on the antenna seats into the rubber antenna
cable cover/tail groove. Route the antenna cable
through the wire channel in the rubber antenna
cable cover/tail. Do not yet attach the adhesive
strip.
Temporarily position the antenna and rubber
antenna cable cover/tail in the selected mounting
area and route the cable from the antenna to the
vehicle's interior by tucking it underneath the
rubber molding around rear window, as shown.
ST2C Starmate Replay User and Installation Guide
ANTENNA
(UNDERSIDE)
Route the cable from the lowest point of the rear
window into the trunk. Take advantage of any
existing cable channels or wiring conduits. For
SUVs, mini-vans & 5-door vehicles, bring the cable
into the vehicle under the rubber molding for the
tailgate, and continue under the interior trim.
From the trunk, or rear of the vehicle, route the
cable around the passenger compartment and to
the front of the vehicle, to the receiver. Take care
not pull the cable across sharp edges that could
damage it, and keep it away from areas where it
might entangle feet. Coil any excess antenna
cable in a location where it can be hidden.
11
Advertisement
Table of Contents
