Table of Contents
Advertisement
Control unit cable
1
Thermal insulation:
2
Spacers:
(MKS-85 to 500)
(MKS-85 to 140)
(MKS-190 to 500)
3
Thermal insulation:
4
Rear panels:
5
Thermal insulation:
6
Thermal insulation:
7
Thermal insulation:
8
Side panels:
(MUS-85 to 100 / MKS-85 to 140)
8
Side panels:
(MKS-190 to 500)
9
Wolf label:
10 Front panel lid:
Only complete the fitting of the casing after the control unit has been installed (page 7).
10 Panel lid l.h. rear:
10 Panel lid r.h. rear:
13 Type plate:
Accompanying documentation:
6
Casing installation
nd
2
stage
1
st
stage
Burner cables
Position (overlapping) around the boiler block and secure with spring clips.
Secure on the boiler with nuts enclosed.
Four spacers at the real panel.
Two bottom spacers per side.
Three bottom spacers per side and one central top spacer.
Loosely fitted to the rear boiler wall.
Centrally locate both parts and secure with self-tapping screws and with the screws (M8x16)
supplied on the rear boiler wall spacers.
Insert from the top between door and boiler front and locate on the boiler front.
Fit loosely to the boiler front and secure with spring clips.
Fit loosely to the boiler front and secure with adhesive strips.
Push the l.h./r.h. casing over the rear panel and secure with the screws
(M8x16) supplied to the lower two spacers.
Secure the l.h./r.h. front and rear panels with screws (M6x10) then push over the rear panel
and secure with the screws (M8x16) supplied on the lower three spacers.
Hook into the front panel lid (10).
Locate and click into the panel with fitted control unit.
Locate on the panel and click into place.
Locate on the panel and click into place.
Affix to the boiler in a clearly visible position.
Affix with the clips supplied to the side of the boiler.
Boiler sensor
Hide quick links:
Advertisement
Table of Contents
