Vertex Standard VX-450 Series Operating Manual page 29

C
ALL
When using the DTMF Paging System
This feature, if enabled, allows the user to change the
3-digit Page Call code, used to call other similarly-
equipped stations. Press (or press and hold) the as-
signed programmable key, followed by the three dig-
its representing the Page Call code of the station you
wish to call. Three tones will be heard after the last
key is pressed (the new code will now be transmitted).
The receiver squelch of the other station will be
opened, and you can begin communication.
When using the 2-tone/5-tone Signaling System
This feature, if enabled, press (or press and hold) the
assigned programmable key to send a 2-tone/5-tone
sequential tone.
When using the MDC1200 System
This feature, if enabled, press (or press and
hold) the assigned programmable key to send
an MDC1200 code.
Press (or press and hold) the assigned programmable
key to enter the "Call Menu" mode.
Press the SIDE-1/SIDE-2 to select the desired Call
mode, then press the [ D ] key to accept the selection.
You may cancel the selection by pressing the [ C ] key.
VX-450 S O
ERIES PERATING
A
DVANCED
M
ANUAL
O
PERATION
Press the SIDE-1/SIDE-2 to select the station to be
called.
You may enter the station's ID number (four digits)
directly from the 16-Button DTMF keypad ( [ 0 ] - [ 9 ] ,
[ A ] - [ D ] , [ # ] : substitute for "E", and [ ] : wild card),
if your transceiver is VX-459.
Press the PTT switch to send an MDC1200 call.
S S
ET ( VX-454
TATUS
Press (or press and hold) the assigned Programmable
key to change the 5-Tone status code. To change the
status code, select the desired digit by [ A ] key, then
change the number by [ B ] / [ C ] key, and store the num-
ber by [ D ] key.
S U /D
OWN ( VX-454
TATUS P
Press (or press and hold) the assigned Programmable
key to select a 5-Tone status code from the pre-de-
fined status list.
)
VX-459 O
AND NLY
)
VX-459 O
AND NLY
27