Vertex Standard VX-450 Series Operating Manual page 11

replace the Battery Holder by pressing down on
both sides of the Battery Holder, if necessary.
Referring to Figure 2, insert the DC plug from
the optional PA-45 AC Adapter into the DC jack
on the rear panel of the CD-49 Desktop Charger,
and then plug the PA-45 AC Adapter into the
AC line outlet.
Insert the battery pack into the CD-49 Desktop
Charger while aligning the slots of the battery
pack with the guides in the nest of the CD-49;
refer to the illustration at the right for details on
proper positioning of the battery pack. If charg-
ing with the transceiver attached, turn the trans-
ceiver off. The antenna jack should be at the left
side when viewing the charger from the front.
If the battery pack is inserted correctly, the LED
indicator will glow red. A fully-discharged bat-
tery pack will charge completely in 1.5 - 3.0 hours
(depending on the battery pack being charged).
When charging is completed, the LED indicator
will change to green.
Disconnect the battery pack from the CD-49
Desktop Charger and unplug the PA-45 AC
Adapter from the AC line outlet.
VX-450 S O
ERIES PERATING
B Y
EFORE
M
ANUAL
B
OU EGIN
1) Always use the Vertex Standard Co., Ltd.
Model FNB-V112LI or FNB-V113LI
Lithium-Ion Battery Pack.
2) Battery Pack shall not be exposed to excessive
heat such as sunshine, fire, or the like.
3) Risk of explosion if battery is replaced by an in-
correct type. Dispose of used batteries according to
the instructions
4) Perform the battery charging where the ambient
tempera-ture range +5 °C to +35 °C. Charge out of
this range could cause damage to the battery pack.
5) Use only the Vertex Standard Co., Ltd. Model
PA-45 AC Adapter.
F 2
IGURE
9