Automatic Time-Out Timer - Vertex Standard VX-920 Series Operating Manual

r If a Speaker/Microphone is available, remove the
plastic cap and its two mounting screws from the
right side of the transceiver, then align the connec-
tor of the Speaker/Microphone on the transceiver
body; secure the connector pin
using the screws supplied with
the Speaker/Microphone. Hold
the speaker grille up next to
your ear while receiving. To
transmit, press the PTT switch
on the Speaker/Microphone,
just as you would on the main
transceiver's body, and speak
into the microphone on a nor-
mal voice level.
Note 1): Save the original plastic cap and
its mounting screws. They should be rein-
stalled when not using the Speaker/Microphone.
2) When you press the PTT switch on the Speak-
er/Microphone, it disables the internal micro-
phone, and vice versa.
Do not remove/install the Speaker/Microphone
in a hazardous location.
r If the Busy Channel Lockout feature has been pro-
grammed on a channel, the radio will not trans-
mit when a carrier is present. Instead, the radio
will generate short beep three times and indicate
18
o
peration
" ÝCH BusyÝ" on the display (16-key and
4-key versions). Release the PTT switch and wait
for the channel to be clear of activity.
r If CTCSS or Digital Coded Squelch (DCS) Lock-
out has been programmed on a channel, the radio
can transmit only when there is no carrier being
received or when the carrier being received in-
cludes the correct CTCSS tone or DCS code.

Automatic Time-Out Timer

If the selected channel has been programmed for au-
tomatic time-out, you must limit the length of each
transmission. While transmitting, a beep will sound
10 seconds before time-out. Another beep will sound
just before the deadline; the "TX" indicator will dis-
appear and transmission will cease soon thereafter. To
resume transmitting, you must release the PTT switch
and wait for the "Penalty timer" to expire.
VX-920 S O
erieS perating
M
anual