Battery Pack Installation And Removal - Vertex Standard VX-920 Series Operating Manual

Battery Pack Installation and Removal

r To install the battery, hold the transceiver with
your left hand, so your palm is over the speaker
and your thumb is on the top of the belt clip.
Carefully mate the battery's four insertion slots
with their corresponding alignment tabs on the
transceiver case, while tilting the Belt Clip out-
ward. Proper alignment occurs with the battery
pack offset about 1/2 inch (1.5 cm) from the top
edge of the battery compartment.
r Guide the pack on to the tabs with a slight inward
pressure, then slide the battery pack upward, until
it locks in place with a "Click".
Tilt the Belt Clip
VX-920 S O
erieS perating
B y
efore
Insert the Battery Pack
M
anual
B
ou egin
r To remove the battery, turn the radio off and re-
move any protective cases. Slide the Battery Pack
Latch on the bottom of the radio toward the front
panel while sliding the battery down about 1/2
inch (1.5 cm). Then lift the battery out from the
radio while unfolding the Belt Clip.
Do not attempt to open any of the recharge-
able Lithium-Ion packs, as they could ex-
plode if accidentally short-circuited.
WARNING
The IS version of the VX-920 is only intrinsi-
cally safe with the use of the FNB-V92LIIS
Battery Pack. To acquire the IS version of the
VX-920, you much select the Intrinsically
Safe battery option at the time of purchase.
Replacement FNB-V92LIIS batteries may
also be purchased however to be considered
IS the radio must have originally been pur-
chased with the IS battery option.
¦ Do not reverse-connect the battery terminals.
¦ Do not parallel-connect the battery terminals.
¦ Do not charge batteries in hazardous loca-
tions.
¦ To reduce the risk of explosion, recharge
the batteries outside of hazardous locations.
11