Samsung SNB-6003 User Manual page 106

setup screen
• Enable SNMP Trap : SNMP trap is used to send important events and conditions
to the Admin.
- Community : Enter the trap community name to receive messages.
- IP address : Enter the IP address to which messages will be sent.
- Authentication failure : It specifies whether an event shall be generated when the
community information is invalid.
- Network connection : It specifies whether an event shall be generated when the
network disconnection is restored.
• Enable SNMP v3 : SNMP version 3 will be active.
- Password : Specify the default password for SNMP version 3. The default
password is <admin4321>.
The default password can be exposed to a hacking thread so it is recommended to change the
`
password after installing the product.
Note that the security and other related issues caused by the unchanged password shall be
responsible for the user.
Password should be longer than 8 characters, no more than 16 characters.
`
4. When done, click [Apply (
SNMP v3 is only able to be set when the secure connection mode is HTTPS.
J
`
Refer to "SSL". (page 103)
Link-Local IPv4 address
An additional IP address may be assigned to assess the camera from the Link-Local
network.
1. From the Setup menu, select the
<Network (
2. Click <Link-Local IPv4 address>.
3. Set the <Link-Local IPv4 address>.
• Auto configure : It specifies Able
or Disable for the Link-Local IPv4
address.
• IP address : Display the assigned IP
address.
• Subnet mask : Display the subnet
mask of the assigned IP.
4. When done, click [Apply (
106_ setup screen
)].
)> tab.
)].