Sealed Burner Rangetop Operation - Wolf Sealed Burner Rangetops Use & Care Manual

Sealed Burner Rangetop Operation

Surface Burners
A spark electrode ignites each surface burner. This control
eliminates the need for continuous open flame pilots. For
added safety and convenience, each burner is designed
with an electronic reignition system. This feature enables
any burner to relight automatically in the event it is acci-
dentally extinguished.
A distinguishing feature of Wolf's low Btu/hr control is its
constant, low heat output without continuous ignitions.
The flame diameter remains full size; only the heat output
is lowered. This patented dual-stacked burner design
makes it possible to enjoy cooking at full flame as well as
maintain control while simmering at the lowest flame
setting.
DUAL-STACKED BURNER ASSEMBLY
The unique dual-stacked burner design combines all of
the burner parts in one assembly.
After removing burner parts for cleaning, it is important
that you reassemble the burners correctly. The burner cap
must be seated flatly on the burner. There is a groove on
the bottom of the burner cap. Adjust the burner cap until it
drops into place and is seated flat on top of the burner.
Failure to do this will result in a poor flame. Refer to the
illustration below.
BURNER IGNITER
CAP
SEALED BURNER
Dual-stacked burner.
Failure to assemble the burner parts correctly could
cause flames or gas to escape and burn between
parts, resulting in poor combustion or damage to the
rangetop.
GRATE PLACEMENT
The low-profile, continuous burner grates are designed for
a close fit. This enables you to move pans easily from one
burner to another without having to lift the pan or have it
tip over between the grates. Each grate sets securely on
dimples on each corner of the burner pan.
The burner grates are interchangeable, excluding the
charbroiler grate with a burner grate.
Position the porcelain-coated, cast iron grates over two
burners. Rubber pads located under the grate support
legs will match up with the dimples on the burner pans.
The burner drip pan holds as much as 2
liquid spillover per two-burner pan.
10
1
/ cups (.6 L) of
2