Standby Mode - Panasonic TH-42PV600AZ Operating Instructions Manual

Plasma television
Hide thumbs Also See for TH-42PV600AZ:
Table of Contents

Advertisement

FAQs
Chaotic image, noisy
No image can be
displayed
Blurry or
distorted image
(no sound or low volume)
Neither image nor
sound is produced
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
An error message
appears
"Control with HDMI"
function does not work
The SD card cannot
be used even when it
is formatted
TV unit goes into

"Standby mode"

An error message
appears
36
Problem
Set "D. PNR" in the Picture menu (to remove noise).
(p. 16)
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 16)
Check "Colour system" (p. 18)
Reset channels. (p. 9 and p. 18)
Is the unit in "AV mode"?
Is the mains lead plugged into the socket outlet?
Is the TV unit turned On?
Check Picture menu (p. 16) and volume.
Is "Sound Mute" active? (p. 7)
Is the volume set to the minimum?
Sound signal reception may be deteriorated.
Check "Sound system" (p. 18)
Set the sound setting of the connected equipment
to "2ch L.PCM".
Check the "HDMI1 input" setting in the Sound menu. (p. 16)
If digital sound connection has a problem, select
analogue sound connection. (p. 32)
Contact the authorized Service Centre.
Switch the TV unit on again with the equipment on.
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 26)
Contact the authorized Service Centre.
The sleep function is activated.
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
Follow the message's instructions.
If the problem persists, contact the authorized
Service Centre.
Actions

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Th-50pv600az

Table of Contents