Wolf WWD30 Installation Manual page 5

Installation Considerations
Installation Considerations
MODEL WWD30
• Model WWD30 must be installed with a Wolf stainless
steel or integrated drawer front. Specific installation
instructions are included with the drawer front.
• The warming drawer platform must be able to support
200 lbs (91 kg).
• The warming drawer platform must be a minimum of
1" (25) above the toe kick to allow for the overlap of the
warming drawer trim.
• For undercounter installations, 23
bottom of the warming drawer opening to the floor is
typical.
1
/ " (597) from the
2
COMBINATION INSTALLATIONS
• Model WWD30 may be installed in combination with a
Wolf built-in oven and/or microwave. Additional clear-
ance between warming drawer and oven openings may
be required. To allow the warming drawer trim and the
oven trim to meet, a
separate the two openings. This will act as the support
platform for the oven and the anti-tip device for the
warming drawer. An anti-tip block may be installed at
the rear of the cabinet in place of the platform. If the
warming drawer is installed above an oven, a
platform is required to allow for clearance of overlaps.
• Model WWD30 may be installed below a Wolf cooktop
or sealed burner rangetop. Allow enough room for gas
and electrical connections for the cooktop.
• Model WWD30 may be installed next to or above
another Wolf warming drawer.
IMPORTANT NOTE: For combination installations, refer to
installation instructions provided with the other Wolf
products for additional specifications.
wolfappliance.com
7
/ " (22) platform may be used to
8
5
7
/ " (22)
8