Download Print this page

Wolf OG30 Installation Manual page 15

Outdoor gas grills
Hide thumbs Also See for OG30:

Advertisement

Outdoor Grill Installation
Outdoor Grill Assembly
Wolf outdoor grills are produced fully assembled and
tested in the factory and require no major assembly in the
field. For the purpose of safe shipping and transit, some
parts such as the briquette trays, warming rack and rotis-
serie components are wrapped inside the grill and require
minor assembly.
Remove all packaging materials, labels and protective
plastic film from the grill.
IMPORTANT NOTE: Do not leave the grill or grill cart in the
sun with the protective plastic film on for an extended
period or it may be difficult to remove.
Verify that all grill components are included: control knobs,
hex-grates, large and small briquette tray assemblies,
rotisserie motor with bracket, spit rod and meat forks,
natural gas or LP gas regulator, basting pan, warming rack
and smoker box assembly.
TO INSTALL BRIQUETTE TRAYS
1) Place the briquette trays into the grill above the
burners with the flash tube at the front as shown in the
illustration below.
2) Place the hex-grates directly above the briquette trays
and make sure the square openings on the hex-grates
are at the front.
FLASH TUBE
Flash tube position.
Install Grill to Cart
Wolf portable grill carts are available to fit all Wolf outdoor
grill models.
1) In a cart application, two mounting screws with nuts
are provided at the bottom right rear corner of the cart
for the transformer. If not provided, drill two holes
using the transformer box as a template. Install the
transformer box.
2) Place grill onto cart. Leave enough room at the back
right rear of the cart to make connection to the
transformer.
3) Once connection to the transformer is made, slide the
grill back until it is fully engaged with the cart.
4) With grill in position, secure grill to cart with four
screws provided. Mounting holes in the upper back
corners of the grill will align with holes in the cart.
Secure with two screws. Remove the drip tray. Install
two screws through side mounting holes below the grill
front panel and into the cart.
15
wolfappliance.com

Advertisement

loading

This manual is also suitable for:

Og36Cart36Cart42Cart30Og42