Table of Contents
Advertisement
First wash cycle
Carry out the first wash cycle without laundry
to remove any water left over from the factory
tests.
1. Check that the transit bolts have been
removed from the back of the machine
(see installation instructions).
2. Turn the tap ON.
3. Pull the detergent drawer out as far as it will
go.
4. Pour half a measuring scoop of detergent
into compartment II. Do not use a special
detergent for delicates or woollens as these
will create too much foam.
5. Turn the programme selector clockwise and
set it to Cottons + Linens, Normal.
6. Set the temperature selector to 90 C.
7. Press the ON/OFF button. The programme
is started.
8. When the programme has ended, press the
,,
ON/OFF button to switch the machine off.
,,
Opening the door / loading the
machine / closing the door
Open the door
Pull the handle on the door towards you
(Fig. 10 ).
Put washing into the machine
! Any items which have been pre-treated with
solvent-based cleaners, such as stain remo-
vers and petrol-based agents must be aired
before they are put into the machine.
Explosion hazard!
! Before loading the machine, ensure that
there are no foreign objects nor trapped
pets in the drum.
Place the washing into the drum so that it is
folded out and loose, with a mixture of large
and small items.
Close the door
! When you close the door, make sure that
nothing is caught between the door and the
rubber seal.
Close the door by pressing it shut until it
snaps into place with an audible click.
Add detergent
Turn ON the tap
The tap must remain ON while drying is taking
place, as the drying process works by
condensation.
en
13
Hide quick links:
Advertisement
Table of Contents
