Appendix C : Service Information - Mackie DL806 Owner's Manual

Hide thumbs Also See for DL806:
Table of Contents

Advertisement

Appendix C : Service Information

Troubleshooting
If you think your DL Series mixer has a problem, please check out the following troubleshooting tips
and do your best to confirm the problem. Visit the Support section of our website (www.720trees.com)
to get some ideas or contact our technical support heroes. You may find the answer to the problem
without having to send your DL Series mixer away.
Here are three useful tips that could correct any of the issues outlined below (or possibly any other issue
that we haven't yet discovered):
(1) — Restart the iPad. Don't just restart the Master Fader app. Restart the iPad! Completely power it
down, then power it back up.
(2) — Restart the mixer. This is especially useful after firmware and software updates where the mixer
and iPad aren't quite on the same page. A simple reboot can sometimes work great wonders.
(3) — Restart the router. Internet disconnectivity got you down? Unplug and re-plug the router.
This may resolve any connection issues.
There are no user serviceable parts. If none of these tips work, please refer to "Repair" on the next page to
find out how to proceed.
No Power
Our favorite question. Is it plugged in? Make sure that the female end of the line cord is securely
seated in the IEC socket of The Power Block and the male end plugged all the way into a live
grounded AC outlet. Make sure the locking barrel connector at the end of the cord attached to The
Power Block is attached to the power connector on the mixer and securely tightened. An LED
on The Power Block will illuminate green to indicate success (whether the mixer is powered on or not).
Our second favorite question. Is the rear panel power switch in the ON position?
Are all the lights out in town? If so, contact the local power company to get power restored.
No Sound
Are all the connections good and sound? Make sure all of the connecting cables work and are
securely connected at both ends. Try the same source signal in another channel, set up exactly
like the suspect channel.
Is the signal source powered on? Is it working (and making union scale)?
DL806 and DL1608 Owner's Manual
35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dl1608

Table of Contents