Advertisement
along the guide rail and connect it to the
insertion slot of the charger. At this time,
keep the power switch of the Palmtronic
set at OFF.
2.
Insert
the tightening screw located on the
bottom side of the charger, into the screw
socket of the Palmtronic and turn it
cloc·kwise until
it
stops.
Make sure it is
securely fixed.
3. Insert the plug of the cord into an AC
power socket
.
The power indicator lamp
(red) and ·the charge lamp (yellow) will light
up to
indicate
that charging has started.
4. When
charging nears
completion,
the
charge lamp will start to flash on and off.
It will go off when charging is completed.
5. When detaching the Palmtronic from the
charger, loosen the screw on the bottom
side of the charger and pullout the Palm-
tronic along the guide rail, being careful
not to damage the insertion slot.
I
•
When the charger is to be used as an
adapter for AC power, it can be operated
by setting the Palmtronic power switch at
ON.
If the power switch is set at OFF,
after completion of operation, charging
will be continued.
•
There is no fear of overcharging even when
the charger is
left
connected to an AC
power source.
•
When it is necessary to use a power
source with a voltage not
indicated
on
the rated
voltage plate, consu It your
nearest Can.on dealer.
How to Use a Dry Battery Cassette
1. Load a dry battery cassette with four new
penlight (size AA) dry
batt~ries.
When
loading the batteries, first
lay
the black
tape, which comes attached with the cas-
sette, on the bottom and then load the
batteries from the minus (-) side accord-
ing to the diagram inside. The Palmtronic
will not function if the direction of the
batteries are incorrect.
2. Load the dry battery cassette into the
battery chamber of the Palmtronic.
3. When changing the dry batteries, take
them out while holding the latch of the
cassette. Change all four batteries at the
same time.
The dry batteries can be
easily taken out by pulling the black tape
of the cassette.
Advertisement
