Installation Of Non-Combustible Facing Material - Heat & Glo SOHO-N-CEB Owner's Manual And Installation Manual

B. Installation of Non-combustible Facing
Material
The non-combustible assembly is located on the left side
of appliance.
CAUTION! Handle with care. Non-combustible mate-
rial may be damaged if dropped.
• Remove and save two screws from upper bracket.
• Remove non-combustible pieces.
• Remove and save two screws from lower bracket.
• Discard brackets.
• Replace screws in holes where brackets were attached
to appliance.
• Attach non-combustible panel to appliance and framing
with supplied screws. See Figures 9.6, 9.7 and 9.8.
CAUTION! Fire Risk. Follow these instructions exactly.
Facing materials must be installed properly to prevent
fi re. No materials may be substituted without authoriza-
tion by Hearth & Home Technologies.
NON-COMBUSTIBLE FACING MATERIAL
SUPPLIED LEFT SIDE OF APPLIANCE
Figure 9.7 Attaching Non-combustible Facing Material
Heat & Glo • SOHO-B-CEB, SOHO-N-CEB, SOHO-P-CEB • 2111-980 Rev. F • 8/11
• Use regular sheetrock screws in non-shaded areas.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• Apply a non-combustible adhesive to attach tile,
stone or other non-combustible fi nishing materials per
manufacturer's instructions.
NON-COMBUSTIBLE
ZONE
Figure 9.6 Complete Installation of Non-combustible Facing
Material
96 cm
81 cm
35