Installation Of The Charging Station - Husqvarna AUTOMOWER 305 Operator's Manual

• Transformer (20)
• Low voltage cable (17)
• Staples (21)
• Connector for the loop wire (18)
• Screws for the charging station (19)
• Measurement gauge (22)
• Solderless coupler for the loop wire (23)
During installation you will also need:
• Hammer/plastic mallet to simplify putting the
staples in the ground
• Combination pliers for cutting the boundary
wire and pressing the contact units together.
• Edge cutter/straight spade if the boundary wire
must be buried.Installation of the charging
station.
3.2 Installation of the charging
station
Ideal position of the charging station
Take the following aspects into consideration when
identifying the best location for the charging station:
• Allow for 3 metres of free space in front of the
charging station
• It must be possible to lay at least 1.5 metres of
boundary wire straight out to the right and left
of the charging station.
• Close to a wall socket. The supplied low
voltage cable is 10 metres long.
• A level surface to place the charging station
on.
• Protection from water spray for instance from
irrigation
• Protection from direct sunlight
• Place in the lower part of a working area that
has a major slope
• Possible requirement to keep the charging
station out of sight for outsiders
• Any aesthetic preferences
For examples of where best to install the charging
station, see 7. Garden example on page 50.
16 - English
3. INSTALLATION